Domande sul link originale:
Before getting started with valve clearance, check the rocker arm end play with feeler gages. It should be between .05mm and .40mm.
Note, if not, you need to adjust the gap by loosening the head and associated bolts, and tapping the rocker arm mounts until the gap is correct.
1. Bisogna allentare i dadi (quali) dei alberi e far rientrare il gioco nella toleranza ?
-----------------------
At this point, sorry no picture, place your thumb and forefinger on the center of the feeler gage and pull then push the gage in place. You should feel even drag on the feeler gage. If one valve is tighter than the other the gage will pull out crooked. Redo the tight valve. It should feel pretty easy to slide the feeler gage in and out.
2. Davvero cosi libero deve scorrere lo spessimetro, senza quasi nessun attrito ?
I let the trans drain for about 10 minute. Then I reinstall the drain plug (torque at 30nm, and filled the trans up with 75W140 synthetic gear oil. I used .8 liters, the spec is .7 to .85, or to the filler hole threads on level ground.
3. Sul GS 1200 qualcuno puo confermare la quantita di olio nel cambio ?
__________________
R1200GS
status: Ok
|
Modalità elencata