[Motopoppi]

Originariamente inviata da mary

Tempo fà qualcuno ha spiegato come inibire l'accenzione del faro del GS accendendo comunque il motore...
Ricordo che bisognava premere una freccia o il reset delle frecce per qualche secondo, ma non ricordo l'esatta procedura.
Chi è in grado di dirmela?

Eccola in inglese:

Turning the Headlights OFF
The procedure is as follows:

1. Turn the ignition on and allow the startup-check cycle to complete. The headlights will be off (this is normal).
2. Hold turn-signal cancel switch for 4-5 secs.
3. Hold right turn-signal switch for 4-5 secs.
4. Start engine.
5. Lights should remain OFF.

This will reset next time you switch off the ignition. The headlights will be off, but the running lights and tail light will remain on.
[Nikos Skarentzos wrote to say that you can use this trick to turn the lights off while you're riding, that is, after you've started the engine. You still have to stop and turn the engine off before you can get the lights back on, however.]


Turning ON the Parking Lights
The procedure is as follows:

1. Turn off the ignition.
2. Within about 60 seconds (as long as the red warning light on the left handgrip switch housing is on), push either turn-signal switch.
3. The "parking lights" will remain on until you restart the ignition. On USA-spec bikes, the parking lights consist of the tail light and the very small light in the bottom of the headlight assembly. The red warning light on the left handgrip will also remain ON.
4. WARNING: Prolonged use of the parking lights will drain the battery.

Turning OFF the Parking Lights

The procedure is as follows:

1. Turn the ignition on, then off. Or just start up the bike and ride away...